A Standard Satellite System installation includes;

1) Site survey and mounting of satellite TV dish to an outside wall/roof of dwelling. Subject to our cable routing and worker safety policy.

2) Route up to one hundred twenty feet of cable between satellite dish and each satellite receiver (set top box) through one exterior wood framed wall, or up from basement / crawl space. Subject to our cable routing and worker safety policy.

3) Connect each satellite receiver to one co-located VCR and television using cables supplied by manufacturer.

4) Connect each receiver to an existing phone jack in same room w/supplied 25' phone wire.

5) Ground system to existing electrical service following DBS Install Installation Standard and local codes.

6) Contact the program provider to activate satellite television programming.

7) Program remote controls to operate TV on/off and volume. Not all remotes can be programmed to operate some televisions.

8) Educate customer on basic system operation. 20 minutes minimum.

9) Clean work space and remove any debris.

10) Customer walk-through inspection and sign off.